Instruction manual

Instruction Manual
760006-A
September 2001
Rosemount Analytical Inc. A Division of Emerson Process Management System SIO Module 4-5
Model NGA 2000 Platform
CLD 7.50 ppm
Measure
Back…
-- Signals --
Sample flow:
Sample press.:
Ozonator:
Converter temp:
Block temp:
Detector temp:
NO/NOx:
Noise level:
>>><<<
CLD 7.50 ppm
Measure
Back…
-- Signals --
T90 time:
Output delay time:
Calibration status:
Linearizer:
Measurement mode:
Operational status:
Health:
Interference:
>>><<<
CLD 7.50 ppm
Measure
Back…
-- Analo
g
Output Setup --
Output number: 1
Choose signal source mdoule…
Choose signal…
Signal value for 0% output: 0.00
Signal value for 100% output: 100.00
Output current: 0…20 mA
Hold output during calibration: No
Signal name: Sample flow
Current signal value: 8.60
Source module: CLD: 1.0
More…
Press the >>> (F5) key to go to additional
menus to select the Primary Variable signal
for the analog output. The Primary Variable
is the actual concentration.
The signal chosen here will be applied to the
analog output (1-8) chosen above.
See appropriate Analyzer module manual for
a list of the signals and their range of values.
Move the cursor the Choose signal… line
and press the Enter (↵) key.
(The list of signals will depend on the module
chosen.)
The Signals menu is displayed.
Selecting the signal
Figure 4-5. SIO Analog Output Setup - Selecting Signal