Instruction manual

Instruction Manual
760006-A
September 2001
Rosemount Analytical Inc. A Division of Emerson Process Management System DIO Module 5-3
Model NGA 2000 Platform
Figure 5-1. System DIO Module – Configure Outputs
Main Menu
↓
Analyzer and I/O, expert controls and setup…
↓
System & network I/O module controls…
CLD 7.50 ppm
Measure
<<< Back… >>>
-- S
y
stem & Network I/O Module Controls --
System SIO module…
System DIO module…
CLD 7.50 ppm
Measure Next… Back… Ackn!
-- DIO Module Outputs --
Inputs…
Output number: 1
Choose module…
Choose signal…
Invert signal: No
Module status: Normal
Slot ID: 1
Signal name: ???
Signal level 000.0
Signal comes from: CLD
CLD 7.50 ppm
Measure Back… >>>
-- Choose Source Module --
Control module 0.0
CLD 1.0
<<<
Press the ↑ ↓ cursor keys to go to System
DIO module… menu line, press Enter (↵).
If there is no corresponding DIO module
installed, a corresponding message will be
displayed instead of a menu.)
Select the desired Output number: in the
range from 1-24.
Use the ↑ ↓ cursor keys to go to Choose
module… menu line, press Enter (↵).
Choose desired source module for the digital
output number (1-24) being configured.
The list of module will depend on the
installed modules.