Instruction manual

Instruction Manual
760006-A
September 2001
Rosemount Analytical Inc. A Division of Emerson Process Management System Configuration and Diagnostics 6-1
Model NGA 2000 Platform
SECTION 6
SYSTEM CONFIGURATION AND DIAGNOSTICS
The system configuration menu and its sub-
menus provides for setup of the system pa-
rameters for the platform. The menu is
accessed from the Main Menu.
NOTE
This section contains information on
System Configuration. See Section
6-12 for system diagnostics.
Figure 6-1. System Configuration and Diagnostics Menu
The following is a short overview of the contents of this section:
Menu Contents
System calibration… Setup of system calibration Section 6
Analyzer module diagnostics… Software error messages
See Analyzer
manual
Date and time… Date and time setup of the Analyzer Section 6-6
Security codes…
Setup of security codes for the different
operating levels
Section 6-7
Network module management… Not used in this module Section 6-8
System reset…
System reset and re-initializing of the
Analyzer
Section 6-11
Loading/saving configuration parameters…
Sending or loading of Analyzer configu-
ration data by the serial interface
Section 6-10
Diagnostic menus… Section 6-12
Control module diagnostics… Software error messages Section 6-12
CLD 7.50 ppm
Measure
Status… Channel Lock… MFG Data
-- Main Menu --
Analyzer basic controls (calibration) & setup…
Analyzer and I/O, expert controls & setup…
System configuration and diagnostics…
Display controls…
Time & Date: 10:30:05 August 10 2001
System tag: Fisher-Rosemount
CLD 7.50 ppm
-- S
y
stem Confi
g
uration and Dia
g
nostics --
System calibration…
Diagnostic menus…
Load/Save configuration (CMMCA)…
Date and time…
Security codes…
Network module management…
System reset…
Pump 1: Off
Pump 2: Off
System tag: Fisher-Rosemount
Measure
Back…
Channel
From the Main Menu, using the ↑ ↓ keys
move the cursor to the System
configuration and diagnostics… line and
press the ↵ (Enter) key.