Instruction manual

Instruction Manual
760006-A
September 2001
Rosemount Analytical Inc. A Division of Emerson Process Management System Configuration and Diagnostics 6-7
Model NGA 2000 Platform
6-6 DATE AND TIME
This menu is used to set the date, time and
format for the Analyzer.
Figure 6-6. Setting Date and Time
Set up a new date or time:
Set the “Minutes,” “Hours,” “Year,” “Day,”
or “Month” lines and make any desired
adjustments. Press the F3 key to set the
new time and date. The “Current time”
line will change to reflect the new time
and date set.
Network updating:
Not used with this model.
From the Main Menu, using the ↑ ↓ keys,
move the cursor to the System
configuration and diagnostics… line and
press the ↵ (Enter) key.
From the System Configuration and
Diagnostics menu, using the ↑ ↓ keys
move the cursor to the Date and time…
menu line and press the ↵ (Enter) key.
In the Date and Time menu: Move to a line
using the ↑ ↓ keys, press the ↵ (Enter) key to
select the parameter.
Select any digit with the ← or → key, set the
value with the ↑ or ↓ key.
CLD 7.50 ppm
-- S
y
stem Confi
g
uration and Dia
g
nostics --
System calibration…
Diagnostic menus…
Load/Save configuration (CMMCA)…
Date and time…
Security codes…
Network module management…
System reset…
Pump 1: Off
Pump 2: Off
System tag: Fisher-Rosemount
Measure
Back…
Channel
CLD 7.50 ppm
-- Date and Time --
Minutes: 0
Hours: 12
Year: 2001
Day: 1
Month: 2
Network updating: Enabled
Current time: 08:45:35 May 01, 2001
Measure
Back…
Set!
Main Menu
↓
System configuration and diagnostics…