Network Device Specification Sheet

ManualsBrandsEmerson ManualsNetwork CardSiteI/O 32/0

Specification for SiteI/O 32/0

DESCRIPTION: The SiteI/O 32/0 is part of the SiteI/O-Line, which allows a complete SiteScan

monitoring/control system to be built a piece at a time. It is a 32 bit microprocessor-based device

designed to monitor up to thirty-two analog, digital, and/or dry contact type signals. Individual hardware

jumpers set signal-type selections. Screw terminal blocks are provided to terminate power,

communication, and input signal wiring.

DIMENSIONS: Module: 11 5/16” H x 11 5/16” W x 2 3/4” D

28.73 cm H x 28.73 cm W x 7 cm D

Enclosure: 20" H x 18" W x 2.87" D

(Painted Steel) 508mm x 457.2mm x 72.89mm

See Enclosure Diagrams for mounting options.

POWER: 24VAC ± 10%, 50-60 Hz., 35 VA power consumption

(120/24VAC 40VA Transformer available)

INPUTS: Thirty-two universal inputs, configurable for 0-5VDC, 0-20mA, or thermistor.

ENVIRONMENTAL

OPERATING RANGE: 0° to 130° F (-17.8° to 54.4° C), 10 to 90% relative humidity, non-condensing

COMMUNICATION: (1) CMnet EIA-485 Port - Control Module network screw terminals

Switch selectable baud rates ARC156 / 9600 or 38.4bps

Recommended wire is: MAGNUM Cable pn A3-ARC-156-2

(32) Analog and/or Digital - screw terminals

Jumper Selectable inputs

Thermistor - 10k ohm @ 77° F, 25°C

0 to 5 VDC - 10k ohm max source impedance

4 to 20mA - 24VDC loop power, 250 ohm input

Dry Contact - 0.5mA sense current

MEMORY: 1 MB Flash Memory, 1 MB Non-volatile battery backed RAM.

PROTECTION: Voltage, current, and ESD protection on incoming power.

Liebert Corporation Page 1 of 5 SL-28073 Rev. 4; 7/03

Summary of content (5 pages)

PAGE 1
Specification for SiteI/O 32/0 DESCRIPTION: The SiteI/O 32/0 is part of the SiteI/O-Line, which allows a complete SiteScan monitoring/control system to be built a piece at a time. It is a 32 bit microprocessor-based device designed to monitor up to thirty-two analog, digital, and/or dry contact type signals. Individual hardware jumpers set signal-type selections. Screw terminal blocks are provided to terminate power, communication, and input signal wiring.
PAGE 2
Specification for SiteI/O 32/0 BATTERY: Seven-year lithium battery provides a minimum of 10,000 hours of data retention during power outages. DIAGNOSTIC LED's: Power: Tx: Rx: Error: Run: LISTED BY: Indicates power on condition Indicates data transmitted on the CMnet Indicates data received on the CMnet Indicates an error within the SiteI/O 10/0 Indicates operating condition of the SiteI/O 10/0 UL 916 (PAZX), cUL C22.2 No.
PAGE 3
Specification for SiteI/O 32/0 INPUT WIRING DIAGRAM V+ In p ut s 5 V M ax, 20 m A M a x Un iv ers a l In p ut Mo d e S el ec t PW R 0 - 5V DC OU T GND DR Y CON TACT PA SS IVE TRA NSDU CER 4-2 0 mA 1 2 V o r 2 4V L OOP I NPUT THER MISTOR 3 WIRE 4 - 2 0m A 4 WIRE 4 - 2 0m A ISO L ATED D C POWER SUPPLY Liebert Corporation OUT PW R GND A A B A B A B B A A B B A A B A B A B A B A B B A A B A B A B A B A B B A A B A A B OUT+ OU TGND PW R OUT+ OU T- B A B A B B A
PAGE 4
Specification for SiteI/O 32/0 COMMUNICATIONS WIRING DIAGRAM Shield CMnet Net Net + N et - Ne t + 18-24 ga Twisted - Pair, Shielded, Low Impedance, Low Capacitance Recommended wire is: Magnum Cable A3-ARC-156-2 ENLOSURE DIAGRAMS Liebert Corporation Page 4 of 5 SL-28073 Rev.
PAGE 5
Specification for SiteI/O 32/0 Enclosure Wall Mounting Enclosure Floor Mounting with Brackets Liebert Corporation Page 5 of 5 SL-28073 Rev.