Instructions / Assembly

ManualsBrandsEmerson ManualsCeiling Fan Parts4-Speed Wall Control with Receiver

SSaaffeettyy IInnssttrruuccttiioonnss

WARNING: To avoid fire, shock, and serious personal injury, follow all instructions

carefully.

1. Read your Owner's Manual carefully before installing the Wall Control. Retain Owner's

Manual for future reference.

2. Before servicing or cleaning the ceiling fan, switch power off at service panel and lock

service panel disconnecting means to prevent power from being switched on

accidentally. When the service disconnecting means cannot be locked, securely

fasten a warning device such as a tag, to the service panel.

ADDITIONAL SAFETY INSTRUCTIONS FOR INSTALLATION

1. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or

circuit breaker box before wiring.

2. Make certain no bare wires are exposed outside the wire connectors.

3. All wiring must conform to National and Local Electrical Codes.

4. Follow the recommended instructions for the proper method of wiring your new Wall

Control. If you feel you do not have enough electrical wiring knowledge or experience,

have your Wall Control installed by a licensed electrician. Any electrical work not

described in this manual should be performed by a licensed electrician.

Ceiling Fan/Light

Wall Control Owner's Manual

Part No. BP7413

Form No. F40BP74130000

Printed in China 01/10

READ AND SAVE THESE INSTRUCTIONS

Model Number

SW405

Air Comfort Products

DIVISION OF EMERSON COMPANY

8100 W. Florissant • St. Louis, MO 63136

• 4-Speed Hard Wired

Wall Control

• Supplied with Receiver

• Supplied with White,

Ivory, and Light

Almond Face Plates

• Includes Light

Dimming Selection

Switch

Model Number

SW406

• 4-Speed Hard Wired

Wall Control

• Single Light

• Supplied with White,

Ivory, and Light

Almond Face Plates

• Use with SW405

(3-way) or SR400

• Includes Light

Dimming Selection

Switch

Part No. F40BP74130000 Form No. BP7413

Summary of content (4 pages)

PAGE 1
READ AND SAVE THESE INSTRUCTIONS Model Number Model Number SW405 SW406 • 4-Speed Hard Wired Wall Control • 4-Speed Hard Wired Wall Control • Single Light • Supplied with White, Ivory, and Light Almond Face Plates • Use with SW405 (3-way) or SR400 • Includes Light Dimming Selection Switch • Supplied with Receiver • Supplied with White, Ivory, and Light Almond Face Plates • Includes Light Dimming Selection Switch Ceiling Fan/Light Wall Control Owner's Manual Safety Instructions WARNING: To avoid fire,
PAGE 2
Installation of Wall Control General Your Emerson Ceiling Fan/Light Wall Control consists of a wall mount transmitter and a receiver which is mounted under the fan ceiling cover. The wall control is designed to separately control your ceiling fan speed and light intensity. Code switches in the wall control may be set in 32 different positions.
PAGE 3
-WAY WIRlNG DIAGRAM: NEW CONSTRUCTION ON BL AC HOT HOT TO E 120V AC SOURC TO LOAD K OU OFF ND FAN/LIGHT WALL CONTROL .... .... ON OFF BLACK ON BLK OFF K GR BL .... BLK SCREWS (2) NOTES TRAVELER WIRE WALL SWITCH BOX COVER FAN/LIGHT DECORATIVE WALL CONTROL WALL PLATE NEUTRAL REMOTE CONTROL RECEIVER LOCATED WITHIN THE CEILING COVER Figure 3 LOAD BLACK GROUND Figure 4 3-WAY INSTALLATION 6. Place wall control into wall box.
PAGE 4
Installation of Receiver (Figure 6) ! Operation of Your Wall Control (Figure 7) 4. Connect the receiver white wire (TO MOTOR N) to the fan white wire. Connect the receiver red wire (TO MOTOR L) to the fan black wire. Connect the receiver blue wire (FOR LIGHT) to the fan blue wire. CAUTION: If no light exist on your ceiling fan, cap the blue wire on the receiver with a wire connector. 5. Push the connected wires up into the junction box and position the receiver in the hanger bracket above the hanger ball.