Owner`s manual

30067-0-0512Page 10
RemoteOperation-ThermostatMode
To operate the remote in Thermostatic mode, press the MODE key
until the LCD screen shows the word ROOM.
Press and hold the SET key until the desired temperature is dis-
played then release the SET key. By pressing and holding the set
key the LCD screen set numbers will increase from 45° to 99° then
restart over at 45°. The LCD screen will display the set tempera-
ture for 3 seconds and the LCD screen will ash the set tempera-
ture for 3 seconds, then the LCD screen will default to display the
room temperature. The replace will turn ON/OFF automatically to
maintain the set temperature.
To change the set temperature, press and hold the SET key until
the desired set temperature is reached then release the SET key.
To deactivate the Thermostatic Mode, press the MODE key. The
word ROOM on the LCD screen will not show when the thermostat
is not in operation.
Note: The highest SET temperature is 99° Fahrenheit
(32° Celsius) and the lowest temperature is (45° Fahr-
enheit (6° Celsius).
Note: The temperature setting probe is built into the re-
mote. Place the remote in a good position to monitor the
room’s average temperature.
Note: Avoid placing the remote too close to the replace
as this will affect the remote’s temperature sensor.
Note: The Thermostat Feature on the remote operates
the replace whenever the ROOM TEMPERATURE var-
ies +/- 2°F (1°C) from the SET temperature.
RemoteFunction-Lock-Out
This remote control includes a “LOCK-OUT” feature that allows
you to “LOCK-OUT” operation of the replace, from the TRANS-
MITTER.
To activate the “LOCK-OUT” feature, press and hold the ON but-
ton and the MODE button at the same time for 5 seconds. The
letters CP will appear on the LCD screen.
To disengage the “LOCK-OUT”, press and hold the ON button and
the MODE button at the same time for 5 seconds and the letters
CP will disappear from the LCD screen and the transmitter will
return to its normal operating condition.
To verify that transmitter is in the CP lock-out mode press any key
and the LCD screen will show “CP”
Note: If the replace is already operating in the ON or THER-
MOSTAT MODES, engaging the “LOCK-OUT” will not cancel
the operating MODE. Engaging the “LOCK-OUT” prevents
only the manual operation of the TRANSMITTER. If in the auto
modes, the THERMOSTAT operation will continue to operate
normally.
RemoteSetup-WallClip
The remote can be hung on a wall using the clip provided.
HowtoResettheFireplace
If for any reason the replace needs to be reset, remove the front
louvered cover, then turn the Main Power Switch to the “OFF” po-
sition. The replace must remain off for 5 minutes.
Note: If the blower is running, allow it to complete its cycle and
shut down automatically before turning the main power switch
to the “OFF” position. This will ensure that the replace has
been properly cooled down.
After waiting 5 minutes, the Main Power Switch can be moved to
the “ON” position. Burner operation will resume.