Owner`s manual

30067-0-0512Page 8
RemoteReceiver
The remote receiver operates on 4 AA-size 1.5V batteries.
It is recommended that ALKALINE batteries be used for maximum
battery life and performance.
The remote receiver has a 3-position slide switch for selecting the
MODE of operation: ON/REMOTE/OFF
• With the switch in the ON position (toward the LEARN but-
ton), the replace will remain on until the switch is placed in
the OFF or REMOTE position, or until the burner switches are
turned off.
• With the switch in the REMOTE position (centered), the re-
place will operate commands received from the remote.
• With the switch in the OFF position (away from the LEARN
button), the replace is off.
Note: It is suggested that the slide switch be placed in the off
position if you will be away from your home for an extended
period of time.
BATTERY COVER SLIDES ON/OFF
LEARN BUTTON
SLIDE SWITCH
OFF/REMOTE/ON
BATTERY
COMPARTMENT
FREQUENCY
ADJUSTMENT
ACCESS HOLE
RemoteSetup-Install/ReplaceBatteries
Both the handheld remote control and the remote receiver (located
inside of the replace) are battery operated. These batteries will
need to be replaced periodically as part of the normal mainte-
nance of the heater.
ReplacetheRemoteControlBatteries
Slide open the battery compartment panel located on the back of
the remote control.
BATTERY COMPARTMENT
Remove the old batteries and install two AAA sized batteries into
the battery compartment.
Note:
Verify that the batteries are installed in the proper
position.
It is recommended that ALKALINE batteries be used for maximum
battery life and performance.
ReplacetheRemoteReceiverBatteries
Remove the lower louvered panel of the replace and turn the
Main power switch to the “OFF” position.
Lift the remote receiver from its location on top of the blower hous-
ing. The remote receiver is held onto the blower housing with hook
and loop tape.
Note:
Do not disconnect the wires.
RECEIVER LOCATION
ADJ. LEARN
REMOTE ONOFF