Owner`s manual

30067-0-0512 Page 9
Slide open the battery compartment panel located on the bottom
of the remote receiver.
BATTERY COVER SLIDES ON/OFF
LEARN BUTTON
SLIDE SWITCH
OFF/REMOTE/ON
BATTERY
COMPARTMENT
FREQUENCY
ADJUSTMENT
ACCESS HOLE
Remove the old batteries and install four AA sized batteries into
the battery compartment.
Note:
Verify that the batteries are installed in the proper
position.
It is recommended that ALKALINE batteries be used for maximum
battery life and performance.
It may be necessary to program the remote receiver to LEARN
the security code of the transmitter upon initial use, if batteries
are replaced, or if a replacement transmitter is purchased from
your dealer. When matching security codes, be sure the slide but-
ton on the receiver is in the REMOTE position; the code will NOT
“LEARN” if the slide switch is in the OFF position. Program the
remote receiver to LEARN a new security code by pushing in the
LEARN button on the top of the remote receiver and then pressing
any button on the transmitter.
BATTERY COVER SLIDES ON/OFF
LEARN BUTTON
SLIDE SWITCH
OFF/REMOTE/ON
BATTERY
COMPARTMENT
FREQUENCY
ADJUSTMENT
ACCESS HOLE
A change in the receiver’s beeping pattern indicates the transmit-
ter’s code has been programmed into the receiver.
If you are unsuccessful in matching the security code on the rst
attempt, wait 1 - 2 minutes before trying again.
RemoteSetup-SettingtheTemperatureUnits
To change the temperature units press the ON key and the OFF
key on the remote at the same time.
Note: The factory setting for the temperature units is degrees
Fahrenheit.
StartingtheFireplace-Remote
The remote control has two modes for operating the replace;
Manual and Thermostatic. When operating in Manual Mode, the
replace can be turned on/off manually. When operating in Ther-
mostatic Mode, you set the desired room temperature and the re-
mote will automatically turn the replace on/off to achieve the set
temperature.
To operate the replace with the remote, the switch on the remote
receiver must be set to “Remote” and both burner switches must
be in the “ON” position.
Note: The remote receiver emits one beep when it receives an
ON or OFF command manually, but no beep when cycling on
and off automatically in THERMOSTAT mode.
RemoteOperation-ManualMode
To turn the replace on press the ON key on the remote. The re-
place will begin the lighting sequence and the remote LCD screen
will show ON. After 3 seconds the LCD screen will default to dis-
play room temperature and the ame icon will appear.
To turner the replace off, press the remote’s OFF key. The re-
place will shut off and the LCD screen will show OF, after 3 sec-
onds the LCD screen will default to display room temperature.