Owner`s manual

28365-2-0811 Page 31
7. Remove outside mounting plate with tube attached from wall.
Mark and cut the extra length of the 6 5/8” (168 mm) diameter
tube from the opposite end. Do not crimp or enlarge tube.
8. Attach the 4” (102 mm) diameter ue outlet tube onto the rigid
venting system or directly to replace. Ensure the 4” (102 mm)
diameter ue outlet tube is placed as far as possible onto the
rigid venting system. Mark the 4” (102 mm) diameter ue outlet
tube 2 1/2” (64 mm) beyond the vinyl siding kit or wall. See
Figure 50. Remove the 4” (102 mm) diameter ue outlet tube
from rigid venting system. When installing directly to replace,
tape gasket needs to be used.
9. Mark or wrap tape completely around the tubes at the marked
points to help in making a true cut. Do not crimp or enlarge
tubes.
10. From outside: Push the 6 5/8” (168 mm) diameter inlet tube/
mounting plate onto end of rigid venting system to correct posi-
tion. Fasten the outside mounting plate to the vinyl siding kit or
wall with (4) 10 x 1 1/2” screws. (Ensure upward slope).
11. From inside: Attach the inlet tube to the collar on the back of
the replace (or the rigid venting system) using (3) self tapping
screws.
12. Seal the 4” (102 mm) diameter ue outlet tube. Follow instruc-
tions and diagram (Figure 51).
13. Fasten 4” (102 mm) diameter ue outlet tube in place. Do not
“twist” the ue outlet tube into the replace collar (or rigid vent-
ing system). Hold the tube by the seam and push in using a
perpendicular “rocking” motion. This ensures the seam on the
tube stay intact.
14. Fasten vent cap end using (3) 10 x 1/2” screws to mounting
plate.
OUTSIDE WALL
MEASURE
VINYL SIDING KIT DV822
OUTSIDE MOUNTING
PLATE
EXT.WALL
SURFACE OR
VINYL SIDING KIT
FLUE
PIPE
CUT
2½”
BEYOND EXTERNAL
WALL SURFACE OR
VINYL SIDING KIT
Figure 49
Figure 50
1
”
VENT CAP END
APPLY SEALANT
ON THE INSIDE
DO NOT PLACE
OVERLAPPED
SECTION OVER
THE SEAM IN THE TUBE
Figure 51
Note: Tape gasket to be applied prior to installing to replace ue outlet tube
only. Tape gasket should not be used when mating the ue outlet tube to a rigid
venting system.
