Owner`s manual

28365-2-0811Page 48
PLEASE NOTE

some expansion and/or contraction noise during the start
up or cool down cycle. Similar noises are found with your
furnace heat exchanger or car engine.
It is not unusual for your gas replace to give off some odor the
rst time it is burned. This is due to the curing of the paint and any
undetected oil from the manufacturing process.
Please ensure that your room is well ventilated - open all
windows.


installed, place fan in the “OFF” position during this time.
IMPORTANT: Turn off gas before servicing appliance. It is
recommended that a qualied service person perform these check-
ups at the beginning of each heating season.
 
Keep the control compartment, logs, and burner areas surrounding
the logs clean by vacuuming or brushing at least twice a year.
Cleaning Procedure
1. Turn off pilot light at gas valve.
2. Remove glass front. (See Glass Removal)
3. Vacuum burner compartment.
4. Reinstall glass front.
5. Ignite pilot. (See Lighting Instructions)
6. Operate the pilot burner. If it appears abnormal call a service
person.
 
The appliance and venting system should be inspected before
initial use and at least annually by a qualied service person.
Inspect the external vent cap on a regular basis to make sure
that no debris is interfering with the air ow.
Glass Cleaning
It will be necessary to clean the glass periodically. During start-up
condensation, which is normal, forms on the inside of the glass and
causes lint, dust and other airborne particles to cling to the glass
surface. Also initial paint curing may deposit a slight lm on the
glass. It is therefore recommended that the glass be cleaned two
or three times with a non-abrasive household cleaner and warm
water (we recommend gas replace glass cleaner). After that the
glass should be cleaned two or three times during each heating
season depending on the circumstances present.
General Glass Information
WARNING: Do not operate appliance with the glass front
       

Only glass approved for use by the manufacturer in replace may
be used for replacement. The glass replacement should be done
by a licensed or qualied service person.
WARNING:
1. The use of substitute glass will void all product warranties.
2. Care must be taken to avoid breakage of the glass.
3. Under no circumstances should this appliance be operated
without the glass front or with a broken glass front. Replacement
of the glass (with gasket) as supplied by the manufacturer
should be done by a qualied service person.
4. Do not abuse the glass by striking or hitting the glass.

attempt to clean glass when glass is hot.
Glass Removal and Replacement (Figure 66)
1. Lower bottom control cover.
2. Release two glass frame clamps at bottom of rebox.
3. Remove glass frame.
4. Place glass frame onto rebox.
5. Attach two glass frame clamps at bottom of rebox.
6. Align clips on top louver with slots on front posts.
7. Close bottom control cover.
Figure 66
GLASS FRAME
ASSEMBLY
GLASS FRAME CLAMP
MAINTENANCE AND SERVICE