Owner`s manual

28365-2-0811Page 56
1. Using gloves, unpack liner components and check for
damaged or missing components.
2. Lower bottom louver and remove upper louver on
replace.
3. Remove glass frame assembly from replace.
4. Remove rear logs from burner assembly.
5. Place brick panel (rear) against rear wall in replace.
Note: The top edge will have a half-moon cutout relief to
match up with the rear ue vent hole.
6. While holding the front nished edge of a side brick
panel (left & right), place brick panel (sides) against side
walls in replace. NOTE: The side brick panels should
be installed with full brick pattern at the bottom. Move
side panels rearward until the back edge meets the rear
brick panel. Slide side brick panels down so they rest on
rebox bottom, and brick joints match up with the back
brick panel.
7. Align grout lines on top brick panel with the grout lines
on the side brick panels. Place the top brick panel into
brick panel holder. With needle-nose pliers, carefully
bend hold-down tabs on brick panel holder over the
edges of the top brick panel. The hold-down tabs will
securely hold the top brick panel in place.
8. Replace rear logs onto burner assembly. (Refer to log
placement, pages 36 and 37.
9. Attach glass frame assembly onto replace.
10. Raise bottom louver and replace top louver onto
replace.
11. Installation of optional brick liner is complete.
