Owner`s manual

26284-3-0813Page 12

Figure 8 shows a correct pilot ame pattern. The correct ame will be blue and will extend beyond the thermocouple/thermopile. The
ame will surround the thermocouple/thermopile just below the tip. A slight yellow ame may occur where the pilot ame and main burner
ame meet.
After use, cleaning of the pilot burner may be required for the proper ame. The pilot orice can be cleaned with high pressure air or by
placing under running water. Pilot orice must be dry before replacement. Use a pipe cleaner to clean inside the pilot after the pilot orice
has been removed.

1. Disconnect the pilot supply line at the pilot burner.
2. Remove pilot orice from pilot burner. It may be necessary to tap on pilot burner in order to remove the pilot orice.


If pilot ame pattern is incorrect
• See Troubleshooting, page 15

The main burner ame will be completely yellow.

When the main burner is ignited it will take a few seconds for the full ame pattern to develop.
When the main burner is extinguished it will take a few seconds for the ames to disappear. It is normal to have the ames burn down
near the rock wool, as the remaining gas is burned.
