Owner`s manual

27407-5-1010Page 18
DECORATIVE GLASS
GLASS MUST NOT BE PLACED ON TOP OF OR
NEXT TO BURNER. GLASS TO BE PLACED ONLY
TO THE OUTSIDE OF THE FLANGED OPENING.
DECORATIVE ACCESSORY INSTALLATION
WARNING
Failure to position the parts in accordance with the dia-
grams and instructions below or failure to use only parts

property damage or personal injury.
Notice: The Loft series burners may be operated with or
without the Decorative accessory options. Follow the
directions below should you choose to enhance your
Loft burner with any one of the available decorative
options.
DECORATIVE GLASS ACCESSORY PLACEMENT
The Decorative Glass options are available in various colors and
package sizes. Choose the size appropriate for your replaces.
See list on page 7.
CAUTION
Use of gloves and eye protection is required while applying
the decorative glass.
INSTALLATION
1. Application of the Decorative Glass should only be performed
after the Loft burner has been fully installed, secured and test-
ed for leaks. If operating the burner with a Remote Control,
make sure all batteries are installed and that the Loft burner
operates with the remote correctly.
3. To install the Decorative Glass, cut off a corner of the plastic
bag and proceed to apply the glass to the rear shelf on the
Loft burner (area behind the burner). Apply only enough glass
to the Top Cover to cover the black metal surfaces. Do not
allow the glass to fall around the burner tube. See Figure 30.
Apply the remaining decorative glass to the front sloped sur-
face of the Top Cover. Start by placing the glass along the
front edge of the top cover, then gradually place the glass
up the sloped top until completely covered. Do not allow the
glass to fall around the burner tube. See Figure 31.
CAUTION
Glass must not be placed around the ends of the Loft burn-
          
valve.
Figure 16
Figure 17
Figure 18