Heritage Vent Free Cast Iron Stove Installation Manual
31208-1-1112Page 40
CIB4-1 OPTIONAL BLOWER INSTALLATION INSTRUCTIONS
CAUTION
Sharp edges, use protective gloves when installing.
Installation
the four hex-head screws that were loosened in Step 1. Push
10 x 1/2" screws on left side of the appliance. NOTICE: Some
are missing from part removed from unit, discard wire channel
removed from unit and continue installation with appropriate
5. Route fan control wires through rectangular notch on wire
channel - left.
Figure 26 -VFD20CC shown
8. Attach 1/4" push-on terminal from white wire on the fan control
9. Insert AUTO/OFF/ON switch into rectangular notch on wire
channel - left.
10. Install rheostat through hole in wire channel and align small
11. Use an 11/16” wrench to tighten rheostat nut on stationary portion
NOTICE: Nut is self-tapping and
into slot.
15. Route wires from fan control and ON/OFF/REMOTE switch
within wire channel.
16. Attach wire channel to channel divider with two 10 x 1/2" screws
from Step 4.
Fan Control