Heritage Vent Free Cast Iron Stove Installation Manual

31208-1-1112Page 42
CIB3-1 OPTIONAL BLOWER INSTALLATION INSTRUCTIONS
CAUTION
Sharp edges, use protective gloves when installing.
Installation
 

          


 
the four hex-head screws that were loosened in Step 1. Push

  

       
10 x 1/2" screws on left side of the appliance. Note: Some

are missing from part removed from unit, discard wire channel
removed from unit and continue installation with appropriate

5. Route fan control wires through rectangular notch on wire
channel - left.
 

 

8. Attach 1/4" push-on terminal from white wire on the fan control

9. Insert AUTO/OFF/ON switch into rectangular notch on wire
channel - left.
10. Install rheostat through hole in wire channel and align small

11. Use an 11/16” wrench to tighten rheostat nut on stationary
Note: Nut is self-tapping

 
 


into slot.
          

15. Route wires from fan control and ON/OFF/REMOTE switch
within wire channel.
16. Attach wire channel to channel divider with two 10 x 1/2" screws
from Step 4.
 
Figure 28 - DVP30CC Shown
DVP30CC Shown