Installation & Assembly

ASSEMBLY AND INSTALLATION INSTRUCTIONS for PR1
Rack Assembly
1) If your rack is plated it is best to keep the tissue on during installation to avoid fingerprinting.
2) Attach the arms to the upper hanging rectangle, leaving the button head screws loose.
3) Place the arms over and on the outside of the lower rectangular base.
4) Insert the lower button head screws through the arms and the rectangular base positioning the arms squarely. Tighten the lower
button head screws.
5) Square up the rack by aligning the arms so they are perpendicular to the upper and lower rectangles. Tighten the upper button
head screws.
6) We recommend that you anchor your rack into the solid wood of ceiling joists or beams. Carefully measure the area where the
rack is to be hung and install the ceiling screw hooks directly into the wood joists. If it is not convenient to hang your rack
directly into wood joists you may use the new-technology DRYWALL anchors enclosed with your rack. The steel anchors are
very strong and when installed in drywall will hold 200 lbs. each. Two anchors hold about 400 lbs. Follow the instructions in
the Toggler kit.
7) Install the ceiling screw hooks. Your local hardware store can advise you if special hardware is needed for your particular
kitchen.
8) The assembly is now complete. Distribute your cookware uniformly around the rack.
9) All of our hammered steel racks are finished with an industrial wax designed to give years of protection to the rack. Cleaning is
easily done with a damp cloth. Dry thoroughly after cleaning. If a touch-up is ever needed we recommend a "Pledge" like wax
product.
10) The care and cleaning of our copper and brass units must be done with a low abrasive cleaner such as “Flitz”. Chrome racks are
best cleaned with a good quality glass cleaner like “Windex”. Our high quality plating will age & tarnish the same as solid
material. A periodic cleaning will restore your rack to its original brilliance.
Grid Assembly
1) Slip the 6 grid brackets over the lower rectangular base with the “L” portion pointing to the inside. Center one bracket on
each end and on the inside of each arm.
2) Place the grid on the brackets.
3) Hang your pot hooks from the interior squares only. Do not hang them from the perimeter or the cut portions of the grid.
Distribute your cookware evenly.
4) The grid has been treated with a finish which will resist corrosion and tarnish. It can be cleaned with a damp cloth and dried
thoroughly. Please do not use abrasive cleaners.
It is important that your rack is assembled correctly. If the unit is assembled or used
incorrectly, it could become unstable and collapse, possibly causing injury.
If you need help, please call 1-877-ENCLUME
Enclume Design Products, Inc.
24 Colwell Street, Port Hadlock, WA. 98339
Phone [phone]  Fax [phone]
www.enclume.com
W A R N I N G