Product Manual

ManualsBrandsEndurance Marine Manuals1,000 - 2,900 Lb. Capacity Winches12 Volt DC Powered Electric Winch — 2,000 Lb. Capacity, Stainless Steel Cable

Endurance Marine Products Ltd

210—19138 26 Ave Surrey, BC V3S 3V7

T 604 535 0669 TOLL FREE 1 877 535 0669

Info@endurance-marine.com

www.endurance-marine.com

Electric Winch

Installaon & Operaon Manual

Permanent Magnet

12 V DC

EMD2000SS STAINLESS STEEL WINCH

TO PREVENT SERIOUS INJURY, READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USE

Due to connuing improvements, actual product may dier slightly from the product described herein

Summary of content (8 pages)

PAGE 1
Endurance Marine Products Ltd 210—19138 26 Ave Surrey, BC V3S 3V7 T 604 535 0669 TOLL FREE 1 877 535 0669 Info@endurance-marine.com www.endurance-marine.
PAGE 2
The Endurance winch is powered by a 1.5 hp permanent magnet motor designed for intermittent general duty use. It is not designed as an industrial hoist or to be used in the movement of people. A free spool clutch disengages the gear box to allow cable to be manually pulled out.
PAGE 3
SAFETY WARNINGS & PRECAUTIONS 1 Do not operate winch under influence of drugs or alcohol 2 Read manual before using any winch 3 Always use heavy gloves when handling wire rope 4 Never hook the cable back upon itself. The cable can break under tension and cause injury and damage. See Figure 1 5 Stay clear of wire rope and keep others away when in operation or with load on wire. Do not stand in line with a cable under tension 6 Inspect winch and wire rope before each use.
PAGE 4
SAFETY WARNINGS & PRECAUTIONS (continued) Avoid continuous pulls from extreme angles as this will cause the wire rope to pile up on one end of the drum (Figure 2). This can jam the wire rope in the winch causing damage to the rope or the winch. CAUTION Keep hands clear of wire rope, hook and fairlead opening during operation.
PAGE 5
PAGE 6
WINCH OPERATION 1. CLUTCH OPERATION: The clutch is operated by pulling out the Clutch Knob (part#6) and rotating it about 45-90 degrees, see Figure 6. This will allow you to freespool the winch. Turn Clutch Knob (part#6) until it pops back into place this makes it go fully in gear CAUTION Never release the wire rope while under tension. Doing this can badly damage the winch and/or cause property damage and serious injury 2.
PAGE 7
PAGE 8
TROUBLESHOOTING SYMPTOM Motor does not turn on POSSIBLE CAUSE SUGGESTED REMEDY Switch assembly not connected properly Insert switch assembly firmly into the connector Loose battery cable connection Tighten nuts on cable connectors Defective switch assembly Replace switch assembly Defective motor Check for voltage at armature port with switch pressed. If voltage is present replace motor Water has entered motor Drain and dry.