Product Manual
![](/manual/endurance-marine/emd2000ss/product-manual-english/images/img-8.png)
8
TROUBLESHOOTING
SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY
Motor does not turn on Switch assembly not connected
properly
Insert switch assembly rmly into the
connector
Loose baery cable connecon Tighten nuts on cable connectors
Defecve switch assembly Replace switch assembly
Defecve motor Check for voltage at armature port
with switch pressed. If voltage is
present replace motor
Water has entered motor Drain and dry. Run in short bursts
without load unl completely dry
Motor runs too hot Long period of operaon Let winch cool down periodically
Motor runs slowly or without normal
power
Baery run down Recharge baery by running vehicle
engine
Insucient current or voltage Clean, ghten or replace the
connector
Motor runs, cable drum does not turn Clutch not engaged Push clutch knob (part#6) into IN
posion. If that does not work, ask a
qualied technician to check and
repair
Motor runs in one direcon only Defecve switch assembly Replace switch assembly
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE
TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF
ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR
SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS THERETO.