User Manual

NOTE: At any function setting, pressing the MENU button will exit the function mode.
WARNING: FIRE HAZARD
When using the Program Mode to set the battery charging parameters, please consult the battery manufacturer on all the voltage and
current settings. Using the wrong setting to charge battery may overcharge, damage the battery and may cause a re.
Appendix A3
VERSION: REV. 1.0
Press SEL to return to change current
CH1 PROGRAM
BULK VOLTAGE
CH1 PROGRAM
FLOAT VOLTAGE
CH1 PROGRAM
BULK CURRENT
CH1 CHARGE MODE
CH1 PROGRAM
ABSORPTION TO FLOAT
CURRENT
Display shows Program & Bulk
Voltage as currently set.
Display shows Bulk Current as
currently set.
Display shows Absorption to
Float as currently set.
Display shows
Charge Mode as
currently set.
Display shows the Float
voltage for Program.
Press SEL
to return to
change voltage
Press SEL
to return to
change voltage
Press SEL
to return
to change
current
Press SEL
to return to
change mode
Press MENU to exit settings
Back to Appendix A1
Battery Type
Continues from
Appendix A2
CH1 Battery Type Menu
Press SEL
to change
battery type
Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu
Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu
Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu
Press SET to keep the
current setting and
toggle to the next menu
Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu
Press SET to keep the current setting and toggle to the next menu
Press SEL
to enter
Voltage Menu
Press SEL
to enter
Voltage Menu
Press SEL to change voltage
(13.0V to 13.8V in 0.1V steps)
Press SEL to change voltage
(13.8V to 14.8V in 0.1V steps)
Press SEL
to enter Max
Current Menu
Press SEL
to enter Low
Current Menu
Press SEL
to enter Mode
Menu
Press SEL
to change
current
Press SEL
to change
mode
Press SEL
to change
current
CH1 Bulk Current “h” setting
This setting is used to determine the maximum
output current that the charger is capable of.
Choose between 5 to 30A
CH1 Absorption to Float Current “L” Setting
This setting is used to determine when the battery
is full. Once the current ow reaches this number or
below, the charger deems the battery to be full and
will shift the charger to the oat state. If running
constants loads i.e. Fridge etc, set the charger to the
highest “L” number: Choose between .3 to 6A
(Subject to H setting see page 12)
PROGRAM MODE
Charger conguration is a simple step by step process as shown below.
For Tech Support call Enerdrive on 1300 851 535
NOTE: The current setting below is based on the EN3DC30-24 battery charger.