Manual
Battery Capacity Indicators:
LED4 LED3 LED2 LED1
Capacity LED2 (100%) LED3 (75%) LED4 (50%)
<50%
(Blinking)
<50%
(Blinking)
<75% (Blinking)
100%
LED will be showing Battery Charging Prole as below:
LED 1 LED 2 (100% Indicator) LED 3 (75% Indicator) LED 4 (50% Indicator)
Algorithm 30+ Algorithm 20+ Algorithm 10+ Algorithm 1 - 9
For example;
If the charging prole has been selected to #35, LED 1 will be on to represent the charging prole is 30, and LED 4 will blink 5
times to indicate algorithm #35, while LED 2 and LED 3 will remain o.
If the charging prole has been selected to #18, LED 3 will be on to represent the charging prole is 10, and LED 4 will blink 8
times to indicate algorithm #18, while LED 1 and LED 2 will remain o.
4. MAINTENANCE INSTRUCTIONS
1. Do not expose the charger to oil, dirt, mud or direct heavy water spray when cleaning
vehicle.
2. The enclosure of the charger has been tested successfully to EN60529, meeting IP66
compliance.
3. If the detachable AC input power supply cable is damaged, replace with a cable that is a
safety approved detachable cable, 3 conductor, 1.5 mm² minimum, and rated appropriate
for use in the country of destination. AC input type to the charger is, type IEC 60320 C14 plug.
Enerdrive ePOWER Industrial Battery Charger Owner’s Manual (Rev. 1.2)Page 8