User Manual

5. INSTALLING THE CHARGER

WARNING

Enerdrive recommends that all wiring be done by a skilled technician to ensure adherence

to the best practice standards for on-board DC electrical installations. Failure to follow

these instructions can damage the unit and could also result in personal injury or loss

of life.

CAUTION

Before Installing The Unit Consider The Following:

This unit is designed ONLY for internal mounting and should be used or stored in an

indoor area away from direct sunlight, heat, moisture or conductive contaminants.

DO NOT INSTALL IN VEHICLE ENGINE BAY

This is an electronic device cooled by a fan, and will prematurely fail if installed in corrosive

/ moisture rich environments.

When placing the unit, allow a minimum of 75mm of space around the unit for optimal

ventilation.

NOTE

The Enerdrive ePOWER DC2DC+ Battery Charger is designed to be permanently mounted.