User Manual

standard RJ12 cable (maximum length 7.5 meters) is required.
• Install the standard RJ12 cable in your desired location.
• Connect one end of the RJ12 cable to the Interface Port and the
other end of the cable to the Display Panel. Please note polarity.
• The Remote Display is now ready for use.
Running The ePOWER Battery Charger With Portable Generators
It’s very likely that this battery charger will be run via a portable AC
generator. This charger is suitable for use with most sine wave inverter
type generators only. Ensure your generator never runs out of fuel when
running the battery charger. When a generator runs out of fuel, its nal
splutters of life produce very transient AC voltages that can damage
your expensive battery charger.
Be sure to purchase a good generator that has a clean AC output. If
in doubt simply connect a surge diverter (like you would use for your
computer) to the generator.
The Enerdrive ePOWER Battery Charger will run very comfortably from
many of the common market generators around the 1kVA range for 20
and 40Amp charger models and 2kVA for 60Amp charger models.
When you rst start up your portable generator, let the generator reach
a suitable operating temperature and stability before you plug in your
battery charger.
NOTE
Using low cost, unregulated generators will likely result in charger damage
not covered under the enerdrive warranty.
Page 19www.enerdrive.com.au