Instructions / Assembly

P a g e | 2
Overheat protection shut–off
If the heater overheat temperature is reached, it will automatically shut off.
The heater can only resume operation when the user resets the unit. Please inspect and remove any objects on or
adjacent to the heater that may cause high temperature.
To reset the heater:
1. Turn the heater off.
2. Unplug the heater.
3. After 5-10 minutes, plug the unit in again and operate normally.
Caution: If you must use an extension cord, the cord should be at least NO .14 AWG and rated for no less
than 1875 Watts.
You must always make sure there is at least 50 cm (1.5 ft.) of empty space above the heater, 25 cm
(9 in.) from the side and 180 cm (5 ft.) below the heater.
3. OPERATION
You can activate the unit by using the provided remote control or by pressing on the activation button on the unit.
Remote control
Press on the On/Off switch to activate the heater
To operate the heater on low (700W), press the remote control on left side button
To operate the heater on high (800W), press the remote control on right side button
Press the remote control on left and right side button for maximum power (1500W)
To operate LED light, press the remote control top button.
IMPORTANT: To operate properly, the remote must be pointed toward the remote control sensor.
Activation button
Press on the On/Off switch to activate the heater
Press on the button once to operate the heater on low (700W) power.
Press on the button twice to operate the heater on high (1500W) power.
Press on the button three times to activate the LED ambient lighting without heat.
Press on the button four times to activate the LED ambient lighting and to operate the heater on high (1500W)
power.
Press on the button five times to shut the light and heat off.
4. FOR YOUR SAFETY
IMPORTANT INSTRUCTIONS
1. ONLY USE THE UNIT ON A SECURED AND SOLID ATTACHMENT POINT.