Operation Manual
User Manual
>> service >> 26
Service
Troubleshooting
Error message
ERR: ThecomputerreceivesnosignalduringtheRecoveryProgram
or
the computer receives no signal during the BMI-Body Fat
Measurement test mode.
E1: Thecomputerreceivesnosignalfromthemotororthesignalis
interrupted.
ERR2:Thereisnoconnectionbetweenthepowerboardandthecomputer
or the power board is defective.
Solution: see “The computer display is not working“.
The computer display is not working
•Thecomputermightnotbegettingpower.Checkallconnectionsand
cables.
•Ifallconnectionsareinorderandyoustillhavenoreadoutonthedisplay
please contact your local ENERGETICS-dealer.
Heart rate (PULSE) shows no or incorrect read out
•Checkifyourpalmshavepropercontactwiththesensors.Bothpalmshave
to be in contact with the sensors simultaneously. The display may be on a
slight delay.
•Checkallcableconnections.
•Trymoisteningyourhandsiftheyaredry.
The computer has shut down
In rare cases the computer might shut down, mainly because of sudden
changes in the electrical current or static discharge. Normally the E-203
restarts on its own.
Should this not occur restart the computer by pulling the power plug, wait a
few seconds then reinsert it.
Care
Take care that to avoid any moisture penetration. Clean the computer with a
lightly dampened cloth. Do not use abrasive cleaning solutions.
Maintenance
There is no need for special maintenance. Regularly check that all bolts and
connections have a tight fit. Exchange any defective parts immediately. For
assistance contact your local ENERGETICS-dealer.