Owner`s manual

• N.B.: It is possible to change the setting of your unit such that if

the thermostat does not call for heat after 45 minutes, the unit

will remain at the lowest heat setting (#1) but will not shut down

(this is the PILOT ON mode). The stove will remain at the

lowest heat level until the thermostat calls for heat again. If you

prefer that your unit runs following that logic, you need to

change the setting to PILOT ON by simultaneously pressing the

following two buttons on the PC Board for a couple of seconds:

and

Once you do that, the letters P, I, L, O, T, O, N will appear on

the PC Board to let you know that you are in the “PILOT ON”

mode. If you wish to go back to the default thermostatic mode

(i.e. the unit shuts down after 45 minutes if the thermostat does

not call for heat), simply press the same two buttons again for a

couple of seconds. The letters P, I, L, O, T, A, U, T, O will

appear on the PC Board to let you know that you are in the

“PILOT AUTO” mode.

•

NOTE: When in thermostatic mode:

• You should not operate the manual control or play with the

temperature setting.

• YOUR THERMOSTAT SHOULD BE INSTALLED BY AN

AUTHORIZED DEALER OR SERVICE PERSON.

D = MINIMUM DISTANCE 15 FEET

SHOULD BE AVOIDED

FIGURE 17

Thermostat location

THERM

TAT IN

TALLATI

(co

ued)