Cordless Telephone User's Manual

~27~
[Note] Intercom numbers (Handset ID) are not stored in the last 10
numbers dialed log.
Receiving a Telephone Call
1. When an incoming call arrives, the ringer will ring or vibrate unless the
ringer has been turned off.
2.
If the handset is on the charger cradle (ringer will be temporarily
switched to “Ring” if it has been set to “Vibrate”), lift the handset and
start conversation.
3. If the handset is not on the cradle, press any key (except END, and the
Silent soft key) to answer.
Notes:
1. You can press SILENT (Left) soft key if you choose to ignore
the call. Unlike turning off the ringer (from the handset menu),
the SILENT key operation is valid only for the current call.
2. If Caller ID service is available, the LCD will display the
incoming call information. If the LCD shows “Private” or
“Unknown”, the caller’s information may have been blocked by
the caller or the originating phone company.
Receiving an Intercom Call
1. When an intercom call arrives, the ringer will ring or vibrate unless the
ringer has been turned off. Press TALK to answer the intercom call.
2.
If the handset is on the charger cradle (ringer will be temporarily
switched to “Ring” if it has been set to “Vibrate”), lift the handset and
start conversation.
3.
If the handset is not on the cradle, press any key (except PWR, END,
and the SILENT soft key) to answer.
Notes:
1. The LCD displays the caller’s Handset ID.
2. You can press the SILENT if you choose to ignore the call. Unlike
turning off the ringer the SILENT key operation is valid only for the
current call.
Ending a Call
~28~
To end a telephone or intercom call, press END key or place handset into
charger cradle.
Adjusting Receiver (Earpiece) Voice Volume
1. Voice volume can only be adjusted during a call.
2. There are 6 levels of volume selections. Default as
volume 4. Use ¿andÀ scrolling key to adjust.
3. The new setting remains effective for all future calls until changed.
Placing a Call On Hold
1. When a call is in progress, it can be put on hold by
pressing the HOLD (Right) soft key.
2.
To return to the conversation, press “UNHOLD”
Notes:
1. The call being placed on hold can only be “un-hold” by the
handset that puts it on hold.
2. Handset LCD displays a call is being on hold. An alert tone
(double beep) every 30 seconds will remind the handset that a
call is being on hold.
3. If the operation (e.g., call transfer) after putting a call on-hold
fails, the held call may be dropped.
4. You can power off the handset (e.g., change battery) while call
is on hold. After power on again, you can continue the call by
pressing UNHOLD (Left) soft key or select “3” from the Option
menu to terminate the hold state.
5. You can only unhold the call with the base coverage. Once
you’re out of the base coverage, you can return to stand-by
using “Clear hold” function in the OPTION list item #3.
Mute
1.
After a link is established, you can press OPTION (Left) soft key and
press “0” to mute the handset microphone.
2.
When mute is active, the other end will not hear your voice, but still can
speak to you.
3.
To leave the mute state, press “UNMUTE” (Left) soft key. Mute is
 11
00:00:10
Volume:4
OPTION HOLD
 11
You have a
Call on hold
UNHOLD
OPTION