- Outdoor Wireless Client Bridge User Manual

Version 1.02

2.4.8 Back-up the Wireless client bridge’s Configuration

Files

After configuring Wireless client bridge, user can back-up the configuration

files. User can upload the latest back-up files and recover the Wireless

client bridge configuration to the settings specified in the back-up files.

 Downloading Configuration Files

Just being the same with firmware upgrade procedures. After the prompt

character NetARM> is displayed, select “S – Save image to file”, and then

select “6: CONFIG” to back-up the Wireless client bridge configuration as

the figure shown below. The back-up file will be saved as <CONFIG.IMG>

file.

 Uploading Configuration Files

To upload an configuration file to Wireless client bridge, user should select

“F -- upgrade Flash memory” and then select “6: CONFIG”. While the

window starts to display “C” character continuously, click Transfer and

select the preferred <CONFIG.IMG>, then press OK to start transferring file

to Wireless client bridge.

Version 1.02

Note: Remember to press “R” to reboot the system after you upload the

configuration file to the Wireless client bridge