User`s manual

10

Select Mode
1.Add Base

10

Added Base
Number: **
CANCEL
29
Getting Started
Re : Handsets can answer calls from any port or line, unless port is
dedicated to a specific handset or group.
1. Handset Registration.
a. Press button on Base “00” (default), four LEDs will light up in
setting mode.
b. Handset operation: Press .
(It will complete the registration process).
c. Repeat, as needed, to add handsets.
2. Establishing additional Base Units:
a. Press button on new Base.
b. Use Handset 10 or 11 to Add base :
Press
c. Enter 01~07 (Base ID).
d. Repeat, as needed, to add base units.
Notes:
1. Only Handset 10, 11 can assign Base ID.
2. Base“00” is a primary base. All handset must register only on Base
“00”.
3. To avoid interference, the interval between any two bases should
be at least 10 meters (about 30 feet).
1. Plug the transformer end of the Charger AC/DC adaptor into a standard
AC electric power outlet, plug the other end into the “DC In” jack on the
back of the Charger.
2. Install battery pack onto the handset.
3. Install handset antenna.
4. Place handset onto the charger front slot.
5. The phone system is now ready to perform basic functions such as
making and receiving phone calls and intercom calls. No base station
handset programming is needed for basic operations.
REG
REG
MENU 6 1
MENU 8 1
.
Handset and Charger Installation