Service manual

A DJM3.2 MANUAL
Discharge
Set-Point
Pot #5
Setting
Maximum
Temp. ºC
Minimum
Temp. ºC
Reset
Band
Width
ºC
Maximum
Temp. ºF
Minimum
Temp. ºF
Reset
Band
Width
ºF
1 25 (+9.5) 12 (-3.5) 13 77 (+17) 54 (-6) 23
2 26 (+10.5) 11.5 (-4) 14.5 79 (+19) 53 (-7) 26
3 28 (+12.5) 10.5 (-5) 17.5 82 (+22) 51 (-9) 31
4 33 (+17.5) 9 (-6.5) 24 91 (+31) 48 (-12) 43
15.5ºC
60ºF
5
38 (+22.5) 9 (-6.5) 29 100 (+40) 48 (-12) 52
1 29 (+8) 16 (-5) 13 84 (+14) 61 (-9) 23
2 30 (+9) 15 (-6) 15 86 (+16) 59 (-11) 27
3 32 (+11) 14 (-7) 18 90 (+20) 57 (-13) 33
4 37 (+16) 11 (-10) 26 99 (+29) 52 (-18) 47
21ºC
70ºF
5
40.5 (+19) 9 (-12) 31.5 105 (+35) 48 (-22) 57
1 33 (+6) 21 (-6) 12 91 (+11) 70 (-10) 21
2 34 (+7) 19 (-8) 15 93 (+13) 66 (-14) 27
3 35.5 (+8) 18 (-9) 17.5 96 (+16) 64 (-16) 32
4 39 (+12) 15 (-12) 24 103 (+23) 59 (-21) 44
27ºC
80ºF
5
44 (+17) 11 (-16) 33 111 (+31) 52 (-28) 59
1 38 (+6) 25 (-7) 13 100 (+10) 77 (-13) 23
2 38 (+6) 23 (-9) 15 101 (+11) 74 (-16) 27
3 40 (+8) 22 (-10) 18 104 (+14) 72 (-18) 32
4 44 (+12) 18 (-14) 26 111 (+21) 64 (-26) 47
32ºC
90ºF
5
47 (+15) 13 (-19) 34 116 (+26) 56 (-34) 60
NOTE: Room Reset Authority Pot Mislabelling
DJM 3.2 and DJM 3.3 built before Feb./99 that have square blue pots may be numbered
incorrectly. Correct numbering for this pot moving clockwise is from (5) 6 o’clock to (1) 12
o’clock (incorrect labels read 1 to 5). The older round black pots should be numbered
clockwise 1 (6 o’clock) to 5 (12 o’clock).
NOTE: The above table is not linear and reset up and down is equal at a set-point of
about 82ºF. If set-point is below 82ºF there is more reset up from the set-point
than down from the set-point. Refer to the explanation on “OR” and “V” and/or
"X" and "Z" terminals on Page 17 for reset on make/break thermostats, Page 12
for the TE 6100 Penn “Modulating Room Reset” thermostat.
Page 14 Revised: 3/11/99