Installation Manual

IQ 7 / IQ 7+ / IQ 7X Micro Installation and Operation

Step 7: Terminate the Unused End of the Cable

Terminate the unused end of the Enphase Q Cable as follows.

A. Remove 13 mm (½ inch) of the cable sheath from the

conductors. Use the terminator loop to measure 13 mm.

B. Slide the hex nut onto the cable. There is a grommet inside

of the hex nut that should remain in place.

C. Insert the cable into the terminator body so that each of the

two wires land on opposite sides of the internal separator.

D. Insert a screwdriver into the slot on the top of the terminator to hold it in place, and torque the

nut to 7 Nm.

E. Hold the terminator body stationary with the screwdriver and turn only the hex nut to prevent

the conductors from twisting out of the separator.

NOTE: Turn only the hex nut to prevent conductors from twisting out of the separator.

F. Attach the terminated cable end to the PV racking with

a cable clip or tie wrap so that the cable and terminator

do not touch the roof.

WARNING: The terminator cannot be re-

used. If you unscrew the nut, you must

discard the terminator.

Terminator

Body

13mm

Internal view