IQ7 Micro Installation

IQ 7 / IQ 7+ / IQ 7X Micro Installation and Operation

Method 1: Clear this Error Using Enlighten

• Log in to Enlighten and access the system.

• Click the Events tab. The next screen shows a current “DC Resistance Low - Power Off”

condition for the system.

• Click DC Resistance Low - Power Off.

• Where “n” is the number of affected devices, click n devices (show details).

• Click the serial number of the affected microinverter.

• Click Reset DC Resistance Low - Power Off Sensor.

The system displays, “A DC Resistance Low- Power Off reset task was issued on [date and time]

for this microinverter and is still pending.”

Method 2: Use Installer Toolkit to Clear the Condition

On the list of detected microinverters, a green dot or red square appears to the left of each microinverter

serial number. A green dot indicates Status OK. A red square indicates an event for that microinverter.

• Tap the to the left of the serial number to view details for a microinverter event.

• If the microinverter status shows that there is an active DC Resistance Low – Power Off

condition, tap the to send the clear message to the affected microinverter.

The app then indicates that a clear message was sent.

Other Faults

All other faults are reported to the Envoy. Refer to the Enphase IQ Envoy Installation and Operation

Manual at

enphase.com/support for troubleshooting procedures.