User Manual

8
Using Your Radio
Button Key Beeps
The radio will emit a short confirmation beep when pressing any of the function buttons. This
confidence tone confirms the button has been correctly pressed (key beeps may be disabled by
your dealer).
Channel Monitor Button (Dealer Programmable Function)
Tone/squelch defeat disables both CTCSS and DCS tones used and opens the squelch on the radio.
This will allow you to monitor any transmissions taking place that are not on the same
CTCSS/DCS tone on the channel you have selected and listen to any weak signals that may be
breaking up. When activated, you will hear either a rushing noise or any other channel users.
Turning Your Radio On
Turn your radio on using the on / off power button on the front of the radio. The radio will
“beep” and the LED will briefly illuminate yellow. (The beep may be disabled, if required, by your
Entel approved dealer).
Making a Call
Before transmitting on your radio, first ensure that the channel is not in use (yellow or green busy
LED will be illuminated and audio may be heard from speaker). To transmit press and hold the PTT
button on the side of the radio and speak clearly 25-50mm from the microphone. Release the
button to receive.
Transmit Time Out Timer (T.O.T)
A transmit time out timer is enabled on your radio. This will prevent the radio from transmitting
continuously. The maximum transmit duration is set to 90 seconds. If the transmit button is
pressed for this duration, the radio will generate an alert tone 10 seconds before automatically
ending the transmission, when a continuous tone will be emitted (the T.O.T. duration is dealer -
adjustable).
Panic Alarm Siren
The radio has a local panic alarm button, which, when pressed will emit a loud piercing siren from
the radio’s loudspeaker. To operate the local panic alarm, press the orange function button on top
of the radio for a minimum of 2 seconds. To cancel the alarm, simply turn the radio off.
Button Lock (Dealer Programmable Function)
A button lock feature is available to lock the channel control and other side / top function button
modes (except panic alarm). If available, press the assigned button to turn button lock on / off. If a
long button press is used to enable button lock, when unlocking, an error tone will be heard until
the button lock disables.
Low Battery Warning
Alerts you when the battery needs to be recharged. A ‘beep-beep’ audible alert every 20 seconds
and flashing red LED will indicate the battery is towards the end of its duty cycle and needs to be
charged (see battery care on page 4 for information on battery life warning alerts).
Common
7
Preparing Your Radio For Use cont...
Attaching / Removing Audio Accessories
1
To attach, remove the accessory cover by unscrewing the
locking screw anti-clockwise (leave cover attached or store in a
safe place). Attach accessory plug by locating over the socket.
Carefully tighten the locking screw clockwise until finger tight
(do not tighten with a screwdriver etc).
2
To remove, unscrew the locking screw by hand in an anti-
clockwise direction (carefully use a coin or screwdriver if too
tight). Ensure you re-fit the accessory cover so as to protect
the socket.
Charging Your Radio
Several charger options are available. Please refer to your
charger user guide.