User's Manual

Installing the DC Power Supply

1-10 DC Power Supply Installation

3. Removethetapesealonthenon‐conductivebagtoremovethemodule.

4. Performavisualinspectionofthepowersupplyandcableharnessforanysignsof

physicaldamage.ContactEnterasys Networksifthereareanysignsofdamage.Refer

to“GettingHelp”onpage xv fordetails.

Installing the DC Power Supply

WhenyoureceiveyourEnterasysMatrix™Xchassis,acoverplatewillbeinplaceoverall

powersupplyslotsexceptPS1.Thisslotisleftopenforyourconvenience wheninstalling

thefirstpowersupply.

Powersuppliesareinstalledinslotslocatedalongtheright‐frontsideofEnterasys

Matrix™X16‐

CandX8‐Cchassis,oralongthebottomoftheEnterasysMatrix™X4‐C

chassis.ThelocationofthepowersupplyslotsintheEnterasysMatrix™X8‐Cchassisis

showninFigure 1‐3.Ifyouintendtoinstallonlyasinglepowersupply,itcanbeinstalled

in

anyofthepowersupplyslots,althoughslotPS1isleftopenforyourconvenience.

APhillipsscrewdriverisrequiredtoinstalltheDCPowerSupplyinanEnterasys

Matrix™Xchassi s.

ToinstallDCpowersuppliesinyourEnterasysMatrix™Xchassis:

1. AttachtheESDwriststrapshippedwithyourEnterasys

Matrix™Xchassistoyour

wristandplugthecablefromtheESDwriststrapintotheESDgroundingreceptacle

onyourchassis.

Table 1-4 Contents of X-DC Carton

Item Quantity

X-DC power supply 1

Plastic bag containing 5 nuts, 5 lock washers, and two 2-hole

compression lugs.

Enterasys Matrix X Router DC Power Supply Notice 1

Caution: To prevent equipment damage, do not install AC and DC power supplies in the

same chassis.

Precaución: Para evitar que el equipo se dañe, no utilice las fuentes de poder CC y CA

en el mismo chasis.

Note: The illustrations for the following procedure use the Enterasys Matrix™ X8-C

chassis. The procedure is the same for the Enterasys Matrix™ X16-C and Enterasys

Matrix™ X4-C chassis, although the location of the power supply slots is different for the

Enterasys Matrix™ X4-C.