- Enterasys Security Router User's Guide

Backup Configuration
10-38 Configuring Dialer Services
XSR(config-if<D2>)#dialer pool 22
XSR(config-if<D2>)#dialer string 2501
XSR(config-if<D2>)#ip address 20.20.20.1 255.255.255.0
The following command configures backup Dialer interface 1 on Serial sub-interface 2/0:0:
XSR(config)#interface serial 2/0:0
XSR(config-if<S2/0:0>)#no shutdown
XSR(config-if<S2/0:0>)#backup interface dialer1
XSR(config-if<S2/0:0>)#encapsulation ppp
XSR(config-if<S2/0:0>)#ip address 30.30.30.1 255.255.255.0
The following command configures backup Dialer interface 2 on Serial sub-interface 2/0:1:
XSR(config)#interface serial 2/0:1
XSR(config-if<S2/0:1>)#no shutdown
XSR(config-if<S2/0:1>)#backup interface dialer 2
XSR(config-if<S2/0:1>)#encapsulation ppp
XSR(config-if<S2/0:1>)#ip address 40.40.40.1 255.255.255.0
Node C (Called Node) Configuration
The following command configures a Node A user for authentication:
XSR(config)#username toronto privilege 0 password cleartext z
The following commands configure two channel groups with a total of three timeslots on T1 sub-
interface 1/2:0:
XSR(config)#controller t1 1/2/0
XSR(config-controller<T1-1/2:0>)#channel-group 1 timeslots 2
XSR(config-controller<T1-1/2:0>)#channel-group 0 timeslots 1
XSR(config-controller<T1-1/2:0>))#no shutdown
The following commands add a dialer pool member and set the Central Office switch type on BRI
port 1/0:
XSR(config)#interface bri 1/0
XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3
XSR(config-if<BRI-1/0>)#dialer pool-member 28
XSR(config-if<BRI-1/0>)#no shutdown
One of the following commands sets PAP authentication on Dialer interface 0:
XSR(config)#interface dialer 0
XSR(config-if<D0>)#encapsulation ppp
XSR(config-if<D0>)#ppp authentication pap
The following commands add a dialer pool and specify the PPP authenticated username Toro nt o
to map incoming calls on Dialer interface 1:
XSR(config)#interface dialer 1
XSR(config-if<D1>)#no shutdown
XSR(config-if<D1>)#dialer pool 28
XSR(config-if<D1>)#encapsulation ppp
XSR(config-if<D1>)#dialer remote-name Toronto
XSR(config-if<D1>)#ip address 10.10.10.3 255.255.255.0
The following commands add a dialer pool and map incoming Node A calls to Node C’s 2500
number:
XSR(config)#interface dialer 2