- Enterasys Security Router User's Guide

Network Management through SNMP
2-42 Managing the XSR
Via SNMP
The following example creates a row in the aggregate measure table with owner userA. If the
entry is created with owner monitor, replace 5.117.115.101.114.65 with
7.109.111.110.105.116.111.114.
1. Create a row (etsysSrvcLvlAggrMeasureStatus):
1.3.6.1.4.1.5624.1.2.39.1.4.2.1.18.5.117.115.101.114.65.1 = 5 (createAndWait)
2. Configure the destination address (etsysSrvcLvlNetMeasureDst) in the network measure table:
1.3.6.1.4.1.5624.1.2.39.1.4.1.1.14.5.117.115.101.114.65.1 = 1.1.1.1
Schedule a measurement
Via CLI
The following command schedules a measurement immediately:
XSR(config)#rtr schedule 1 start-time now
Via SNMP
1. The following example obtains the current time by querying the etsysSrvcLvlSystemTime
schedule a measure (1.3.6.1.4.1.5624.1.2.39.1.1.1.0).
2. Configure the measurement begin time (etsysSrvcLvlAggrMeasureBeginTime) to now which is
the result of the above query:
1.3.6.1.4.1.5624.1.2.39.1.4.2.1.5.5.117.115.101.114.65.1 = 0796BD1048F5C28F
3. Change the row status (etsysSrvcLvlAggrMeasureStatus) to active and activate the measure:
1.3.6.1.4.1.5624.1.2.39.1.4.2.1.18.5.117.115.101.114.65.1 = 1