User's Guide Hub/Switch 2E253, 2H252, 2H253, 2H258

FLASH Download Configuration Screen
Device Configuration Menu Screens 4-33
Reboot After
Download
(Toggle)
Set the device so it will either reboot or not reboot after completing the
download of an image. This field toggles between YES and NO, when
the Download Method field is set to RUNTIME.
If YES is selected, the device reboots after the download is completed.
If NO is selected, the device continues using the existing firmware
image and stores the new firmware image in FLASH memory. The next
time the device is reset or powered-up, the device boots from FLASH
memory using the new image.
When the Download Method field is set to DOWNLOAD CONFIG,
the setting defaults to YES and cannot be changed. In UPLOAD
CONFIG, the setting defaults to NO and cannot be changed.
TFTP Gateway IP
Addr
(Modifiable)
Enter the IP address of the TFTP gateway server defined on the
General Configuration screen in Section 4.2.4.
Download Server IP
(Modifiable)
Select the IP address of the TFTP server to be used for the download or
upload.
Download File
Name
(Modifiable)
Select the complete TFTP server path and file name of the new image
or configuration file.
Last Image Server
IP
(Read-Only)
See the IP address of the server used for the previous download or
upload.
Last Image File
Name
(Read-Only)
See the complete path and file name of the last downloaded image.
Transfer Status
(Read-Only)
See the status of the current or most recent download or upload.
Table 4-9 Flash Download Configuration Screen Field Descriptions (Continued)
Use this field… To…