Instruction Manual

MAC 10 ORIGINAL VE5 SERVICE MANUAL
PAGE 1
Critical operation conditions of the MAC 10
1. Touching of the HEPA filter could damage it, voiding the warranty on the
filter. The screen is only to protect against an accidental ‘touch’ of the
filter. Never place a hand or tool on the filter. Never lie filter face flat
down on a surface always have filter on its side or back to protect from
damage.
2. Prior to powering the unit, verify that the unit has been plugged into the
correct voltage. The serial number label on the top of the Mac 10 unit
has the required voltage.
3. For reorder prepossess the Mac 10 part number and serial number
should be recorded. This information is located on the serial number
label, located adjacent to the electrical box. If you can’t located the Sales
Order Number please contact Envirco for this information.
Part Numbers Covered by this Manual
11111-XXX Mac 10 Original 2x4 Standard Filter
11112-XXX Mac 10 Original 2x3 ½ Standard Filter
11113-XXX Mac 10 Original 2x3 Standard Filter
11114-XXX Mac 10 Original 2x2 Standard Filter
11115-XXX Mac 10 Original 2x4 RSR Filter Sheet Metal Housing
11116-XXX Mac 10 Original 2x3 ½ RSR Filter Sheet Metal Housing
11117-XXX Mac 10 Original 2x3 RSR Filter Sheet Metal Housing
11118-XXX Mac 10 Original 2x2 RSR Filter Sheet Metal Housing
11157-XXX Mac 10 Original 2x4 RSR Filter Extrusion Housing
11171-XXX Mac 10 Original 2x3 ½ RSR Filter Extrusion Housing
11169-XXX Mac 10 Original 2x3 RSR Filter Extrusion Housing
11170-XXX Mac 10 Original 2x2 RSR Filter Extrusion Housing
Note: A ‘Z’ in the part number indicates that the unit is special. This may
indicate a size change from standard or a special filter. Please contact
the factory for part numbers if this is the situation.