SDS

Carcinogenic potential:
Manufactured stone veneer is not listed as a carcinogen by NTP, OSHA or IARC. It may however,
contain trace amounts of substances listed as carcinogens by these organizations. Crystalline Silica is
a potential trace level contaminate and the potential for exposures requires the following warning
pursuant to California Proposition 65.
WARNING: This product may contain chemicals known to the state of California to
cause cancer, birth defects or other reproductive harm.
SECTION 4 FIRST AID MEASURES
Eye Contact: Immediately flush eyes thoroughly with water. Continue flushing eyes for at
least 15 minutes, including under lids to remove all particles. Call physician
immediately.
Ingestion: Do not induce vomiting. Call physician immediately.
Inhalation: Remove to fresh air. Seek medical help if coughing and other symptoms do not
subside.
Skin Contact: Wash skin with cool water and pH-neutral soap or a mild detergent. Seek
medical treatment if irritation persists.
SECTION 5 FIRE AND EXPLOSION DATA
Auto ignition temperature: Not combustible Flash point: None
Extinguishing media: Not combustible Lower explosive limit: None
Unusual fire and explosion hazards: None Upper explosive limit: None
Hazardous combustion products: None Special fire fighting procedures: None
SECTION 6 ACCIDENTAL RELEASE MEASURES
Sweep or scoop up materials. Avoid actions that cause dust to become airborne. Avoid inhalation of dust
and contact with skin. Wear appropriate personal protective equipment as described in Section 8. Dispose
of non-hazardous waste materials according to local, state and federal regulations.
SECTION 7 HANDLING AND STORAGE
There are no special handling or storage procedures for this product; however, it is best to avoid the
generation of dusts.
SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTION
Although cured concrete products pose little if any exposure risk as packaged/delivered, the generation of
dusts during modification requires that individuals follow all applicable exposure limits and use required
PPE to prevent the possibility of harmful exposure.
General Product Information and Ventilation Requirements: manufactured stone veneer contains
crystalline silica and mineral dust. During dry cutting, sawing, grinding, sanding, breaking, or drilling this
product, dust may become airborne. To avoid overexposure, follow all applicable exposure limits whenever
dust is generated. General dilution alone or in combination with local exhaust ventilation may be necessary
to minimize and maintain exposures below applicable occupational exposure limits.