Operator's Manual

2.1.5 Night Vision Mode On/Off Auto Shutdown

The EXPS3 is compatible with Generation I - III+ Night Vision Devices. At the night vision set-

tings, the reticle brightness is low enough that when viewed with a night vision device, the

reticle image does not bloom.

1. ON/ Night Vision Mode and 8 Hour Auto Shut Down

Pressing the NV Button (see Fig. 4) will turn the sight ON in Night Vision Mode. The sight will

turn on at Level 4 and automatically shut off 8 hours after the last pushbutton control is used.

There are ten (10) NV brightness settings provided to allow the user to adjust the reticle bright-

ness to their preference.

2. OFF/ Turning Sight OFF

To turn the sight off, press both the UP and DOWN arrows simultaneously. Verify that the sight

shuts off by looking though the heads-up window with the night vision device.

3. TOGGLE/ Between Normal and Night Vision Modes

To toggle between NORMAL and NIGHT VISION MODES, press the NV button. When

switching between modes, the sight will remember the last brightness setting. NOTE: When

used with a Night Vision device, always check to make sure the sight is not turned on before

pressing the NV button to turn on the sight in the Night Vision mode. Otherwise, it will toggle

to the Normal mode and saturates the image intensifier.