Operator's Manual

shown in Fig. 5. For both elevation and windage, each click will change the sights point of aim

approximately 1/2 Minute of Angle (MOA), ¼ inch (6.35mm) at 50 yards (45.7m), or ½ inch

(12.7mm) at 100 yards (91m) when zeroing. Also, one full rotation of either knob will change

the point of aim approximately 10 MOA, 5 inches (127mm) at 50 yards (45.7m), or 10 inches

(254mm) at 100 yards (91m) when zeroing. To move the point of impact UP, turn the elevation

adjustment LEFT. To move the point of impact RIGHT, turn the windage adjustment RIGHT.

The HWS elevation and windage adjustments are factory collimated with the bore of the rifle

parallel to the mounting rail. The sight should be close to mechanical zero when mounted on a

properly installed rail. Do not turn the adjustments before mounting the sight on the firearm.

Be sure to check that the mount and sight are securely mounted after initial firing

CAUTION – When encountering an increase in resistance in adjustments, the end of the

adjustment range has been reached. DO NOT turn the adjustments any farther, serious

damage may occur to the sight.