Operator's Manual

should be positioned on the side of the battery cap.
Corrective Action 3: Replace the battery with a new, unused battery that contain a full
charge.
Corrective Action 4: Inspect the battery contact points in both the battery cap and in
the sight itself. Ensure that they are free of debris or corrosion.
Corrective Action 5: Reset the electronics by removing any source of power for
approximately two minutes. This will allow a capacitor in the electronics housing to
drain of power, resetting the electronics. Reinstall the battery and operate the sight as
normal.
Corrective Action 6: Check the battery contacts for corrosion or wear. Clean the con
tacts.
Corrective Action 7: Turn in the sight for unit level maintenance.
Failure: The reticle is fuzzy/ has a ‘halo’ effect/ has more than one reticle:
The reticle is naturally pixilated and the outer circle will appear to be made up of many
small dots. The center circle will still be distinguishable as one dot.
20