Specifications
Sennheiser Communications A/S
Industriparken 27, DK-2750 Ballerup, Denmark, www.eposaudio.com, Printed in China, 02/20, 770-00288/A01
EN
CANADA & USA
Statements regarding FCC and Industry Canada
This device complies with Part 15 of the FCC rules and Innovation,
Science and Economic Development Canada’s licence-exempt
RSSs. Operation is subjected to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including
interference that may cause undesired operation of the device.
This equipment has been tested and found to comply with the
limits for a Class B digital device of the FCC Rules, pursuant to
part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for
help.
Changes or modications made to this equipment not expressly
approved by the manufacturer may void FCC authorization to
operate this equipment.
RF Radiation Exposure Information
Since the radiated output power of this device is far below the FCC
radio frequency exposure limits, it is not subjected to routine RF
exposure evaluation as per Section 2.1093 of the FCC rules. This
device complies with the US and Industry Canada portable device
RF exposure limits set forth for an uncontrolled environment and is
safe for intended operation as described in the user manual.
The device complies with Innovation, Science and Economic
Development Canada’s RF radiation exposure limits set forth for
an uncontrolled environment. Use of other accessories not veried
by the manufacturer may not ensure compliance with Innovation,
Science and Economic Development Canada’s RF exposure
guidelines. These transmitters must not be co-located or operated
in conjunction with any other antenna or transmitter.
FR
CANADA
Déclaration requise par la FCC et l’Industrie Canada
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage, et
2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Information sur l‘exposition aux radiofréquences
Cet équipement est conforme aux limites d‘exposition aux
rayonnements d’Innovation, Sciences et Développement
économique Canada établies pour un environnement non contrôlé.
L‘utilisation d‘autres accessoires non homologués par le fabricant
remet en cause la conformité des normes imposées par la
d’Innovation, Sciences et Développement économique Canada.
Une réduction supplémentaire de l’exposition aux RF peut être
obtenue si le produit peut être maintenu aussi loin que possible du
corps de l’utilisateur ou si l’appareil est réglé sur une puissance de
sortie inférieure, si cette fonction est disponible.
Ce transmetteur ne doit pas etre place au meme endroit ou utilise
simultanement avec un autre transmetteur ou antenne.
Responsible party
Demant Sound USA, Inc.
Little Falls Drive, Wilmington 19800, New Castle, USA
Tel: +1 800-332-7439
ADAPT 460 | ADAPT 460T (SCBT17) BTD 800 USB
USA
FCC ID: R3USCBT17 FCC ID: R3UBTD800
Canada
IC: 2099D-SCBT17 | CAN ICES-3(B)/NMB-3(B) IC: 2099D-BTD800 | CAN ICES-3(B)/NMB-3(B)
Europe
A
v
w A w
Australia/
New Zealand
I
Singapore
Complies with
IMDA Standards
DB100582
Taiwan
S
CCMMnnWWwwwZzX
S
CCAI12LP3060T5
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原
設計之特性及功能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干
擾時方得繼續使用。
前項合法通信，指依電信法規定作業之無線電通信。
低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
Japan
Q
&
201-NNNNNN
Q
&
201-125772
China
c
CMIIT ID: xxxxxxxxx
depending on SNL10
>>or e?
c
CMIIT ID: 2018DJ3234
Thailand
This radio communication device is exempted from license to have and use radio
communication device or set up radio communication station according to the
Notification of NBTC Re: Radio communication devices and radio communication
station exempted from license of radio communication according to the Radio
Communications Act B.E. 2498 (1955).
NBTC Telecommunication | Supervision for public | Call center 1200 (free call)
Brazil
K
Este produto está homologado pela ANATEL, de acordo com os procedimentos
regulamentados pela Resolução 242/2000, e atende aos requisitos técnicos aplicados.
Para maiores informações, consulte o site da ANATEL www.anatel.gov.br
Este equipamento não tem direito à proteção contra interferência prejudicial e não pode
causar interferência em sistemas devidamente autorizados.
XXXXX-XX-XXXXX 04969-19-07356
Mexico
NYCE
La operación de este equipo está sujeta a las siguientes dos condiciones:
(1) es posible que este equipo o dispositivo no cause interferencia perjudicial y
(2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda
causar su operación no deseada.
In compliance with:
ZH
CHINA RoHS
ADAPT 460 | ADAPT 460T
>>input for table required
Parts
Pb
Hg
Cd
Cr
+6
PBB
PBDE
电路模块
Circuit Modules
x o o o o o
电缆及电缆组件
Cables and Cable
Assemblies
x o o o o o
电路开关 - 如果包含
Circuit Breakers -
if available
x o o o o o
本表格依据SJ/T 11364的规定编制。
o : 表示该有害物质在该部件所有均质材料中的含量均在GB/T 26572
规定的限量要求以下。
x : 表示该有害物质至少在该部件的某一均质材料中的含量超出
GB/T 26572规定的限量要求。
BTD 800 USB
Parts
Pb
Hg
Cd
Cr
+6
PBB
PBDE
电路模块
Circuit Modules
x o o o o o
本表格依据SJ/T 11364的规定编制。
o : 表示该有害物质在该部件所有均质材料中的含量均在GB/T 26572
规定的限量要求以下。
x : 表示该有害物质至少在该部件的某一均质材料中的含量超出
GB/T 26572规定的限量要求。
禁止拆解、撞击、挤压或投入火中
切勿置于高温环境中
若出现严重鼓胀，请勿继续使用
电池浸水后禁止使用