Specifications

FeaturesEP-BX6
Page 2-1
Section 2
FEATURES
EP-BX6 Features:
• EP-BX6 is based on the Pentium
®
II or Pentium
®
III Processor operating
at 233 ~ 400MHz (66MHz) or 300 ~ 600MHz (100MHz) on Slot 1.
There are no jumper setting for CPU Speed Setup but detected automati-
cally through the BIOS.
• Designed with Intel’s 82443 BX AGPset.
• Supports up to 768MB of SDRAM (minimum of 8 MB) on board, You can
use 168-pin DIMM x 3. It will automatically detect Extended Data Output
(EDO) DRAM at 66MHz only or Synchronous DRAM memory (SDRAM)
at 66MHz or 100MHz (please see Section 3-2).
• EP-BX6 will not support Error Checking and Correcting (ECC) when using
paritys DRAM memory modules.
• Supports (1) 16 bit ISA slots, (6) 32 bit PCI slots, (1) AGP slot and provides
(2) independent high performance PCI IDE interfaces capable of supporting
PIO Mode 3/4 and Ultra DMA 33 devices. The EP-BX6 supports (6) PCI
Bus Master slots and a jumperless PCI INT# control scheme which reduces
configuration confusion when plugging in PCI card(s).
• Supports ATAPI (e.g. CD-ROM) devices on both Primary and Secondary
IDE interfaces.
• Designed with Winbond W83977TF/EF Multi I/O: (1) floppy port, (1)
parallel port (EPP, ECP), and (2) serial ports (16550 Fast UART).
Note: Japanese “Floppy 3 mode” is also supported.
• Includes a PS/2 mouse connector.
• Allows use of a PS/2 keyboard.
• Features Award Plug & Play BIOS. With Flash Memory you can always
upgrade to the current BIOS as they are released. (http://www.epox.com
please visit our Technical Support section for the latest updates).