Specifications

EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-133
4.3.24 Plate Assembly Bottom MBF
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Lever Jam Clear, Sprin
g
-Hold Rod, Stopper Rod, and
Sprin
g
Nip Pre-Re
g
istration (steps 6 and 7 of RRP 4.1.1).
7. Remove the Frame Assembly MBF.(Section 4.3.19)
8. Remove the Roll Assembly MBF.(Section 4.3.21)
9. Remove the Holder Gear MBF. (Section 4.3.22)
10. Pry the ri
g
ht pivot arm of the bottom Plate by a small flat screwdriver
blade away from the ri
g
ht side of the Frame MBF.
11. Slide the left end of the Bottom Plate away from the left side of the
Frame MBF and remove the Plate Assembly Bottom MBF.
Figure 4-30. “Platen Assembly Bottom MBF” Removal
CHECK
PO INT
Be careful not to lose the Spring Normal Force MBF
because it is not fixed to the Frame MBF nor to the
MBF Bottom Plate.