Specifications

EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-148
4.3.39 Roll Assembly BTR
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Place the BTR Tool under the ri
g
ht end of the BTR shaft, and pry
the end of the shaft off of the Bearin
g
BTR. (See the illustration for
the correct use of the BTR Tool.)
7. Place the BTR Tool under the left end of the BTR shaft, and pry the
left end off of the Bearin
g
BTR. (See the illustration for the correct
use of the BTR Tool.)
8. Lift the Roll Assembly BTR to
g
ether with the Chute Assembly BTR
out of the Frame.
9. Slide the Gear BTR off of the end of the Roll Assembly BTR shaft.
10. Pull the Chute Assembly BTR away from the Roll Assembly BTR.
11. Pull the Roll Trackin
g
BTR to slide off of each end of the Roll
Assembly BTR shaft.
Figure 4-45. “Roll Assembly BTR” Removal
CAUTION
Do not touch the black sponge rubber roll. Handle the
Roll Assembly BTR only by the metal ends.