Specifications

EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-155
4.3.46 Chassis Assembly PS
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the C258MAIN Board.(Section 4.3.49)
7. Remove the Shield Assembly Bottom (E). (Section 4.3.44)
8. Remove the PWBA Hotaru. (Section 4.3.48)
9. Disconnect J221 from the HPS (if the Sensor Toner is installed).
10. Disconnect J222 from the HPS (Fan IOT).
11. Disconnect P/J11 (Fuser).
12. Set the printer on the left side (drive side).
13. Remove the seven screws that secure the Chassis Assembly PS to
the bottom of the Frame. Access one of the screws throu
g
h a hole in
the Chassis.
14. Remove the Chassis Assembly PS by pullin
g
the bottom toward
you, then slidin
g
the Assembly down and out of the Frame.
Figure 4-52. “Chassis Assembly PS” Removal