Operation Guide

Checking Items and Checking Times
113
Remove the Cleaning Sheet from the rear roll paper feeder after a warning buzzer sounds indicating that cleaning is
complete. Finally, install the Spindle unit for the rear roll paper feeder as it was before.
Rear Paper Width Guide
If any paper powder sticks to the rear of the paper width guide on the right-hand side of the rear roll paper feeder,
the fixing strength for the roll paper declines and the roll paper may be slanted when it is fed.
Wipe off any paper powder that is stuck to the rubber parts on the rear of the paper width guide.
A
Remove the rear roll paper.
U “Removing Paper” on page 36
B
Lift the right-hand side paper width guide towards you, and move the triangle to the position shown in the
illustration (between 203 (8) and 254 (10)).
When moved to the position shown in the illustration, the paper width guide is raised from the surface.
Tip:
O See the manual supplied with the Cleaning Sheet for information on loading and using the Cleaning Sheet.
O See the following for information on installing and removing the rear roll paper feeder.
U “Replacing Paper in the Rear Roll Paper Feeder” on page 36
Tip:
You do not need to wipe the left-hand side of the rear roll paper feeder or the front roll paper feeder.