Operation Guide

Ejecting Paper

This section explains how to eject paper.

Ejected Paper Path

After printing, paper is cut to the specified size, and assigned to the ejected paper path determined by the print size.

When the sorter unit is not installed, all prints are ejected to the tray.

When the sorter unit is installed

Ejected prints on the conveyer are carried to the Side tray or to the sorter.

Tip:

O If the prints are on the sorter tray in the back and cannot be easily reached, press and release the Sorter Drive Switch

to slide the tray forward.

Do not move it manually.

O If the sorter tray containing the prints reaches the edge, the sorter stops automatically to prevent the prints from

falling. The printer finishes printing the current copy, and then stops printing after ejecting the current copy into the

sorter tray. Remove the prints from the sorter tray, and then restart printing.To prevent the sorter tray from stopping

automatically, remove prints before too many accumulate in the tray.

Note:

When removing prints from the sorter tray, make sure the prints are complete and that the printer and the sorter unit

have stopped operating.