Administrator's Guide

Settings/Maintenance
34
Periodic Nozzle Check Settings
From the CR Unit Adjustment/Maintenance (03) menu, click Periodic Nozzle Check Settings (0313) from Head
Cleaning (031) to display the screen.
Set whether or not to perform auto nozzle check.
We recommend that this is set to ON, because if it is set to OFF the user needs to manually check for clogging.
After changing settings, click Apply to apply the changes.
Item Explanation
ON Nozzle Check is performed automatically during Pre-operation Check, when a print order starts
and when a print order finishes.
Perform [Auto Cleaning]
during Pre-operation
Check.
Select whether or not to perform cleaning automatically if the nozzle check detects a clog in the
print head during the Pre-operation Check. When selected, cleaning is performed automatically
and a clogging detected message (1501) is only displayed if the clog is not cleared. When
performing cleaning, the time needed for the Pre-operation Check is increased by a few
minutes.
When not selected, a message is displayed without performing cleaning if the nozzle check
detects a clog in the print head during the Pre-operation Check.
OFF Auto nozzle check is not performed.
Back Click to close the Settings/Maintenance screen.
Help Click to display the Help.
Apply Click to apply any changed settings.